Cutting the fret slots -

website fret slot depth The StewMac Japanese Fret Slotting Saw with Depth Stop is a saw used for fret slotting in acoustic and classical guitars The saw has a replaceable blade, an fret slot width Stewmac, Fret Slot Depth Gauge Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough! Dan Erlewine developed this

fret slot depth The jig sits over the fretboard blank The fret cutting saw just fits in the slots and the acrylic being 6mm thick should hold the saw square I  Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and  I tried wide Then program a 3D finish path cutting the same direction as the fret slot I had to play around with the stepover to get a

Share

Share

Link

Turn off sharing Copy link

See all details