G&W Fret Slot Depth Gauge

fret slot depth   Dan fret slot width

I use an Irwin dovetail pull saw with a bit of wood super glued to the saw to stop the cut at the correct depth The saw follows the radius of

Ideally the slot should end up 1o-20% deeper than the fret tang - the small gap underneath is filled usually with superglue Good luck Thanks for the reply Fret slot depth should conform to the curve of the top of fretboard, remaining a constant depth approx 3mm Top

slot dewa 99 fret slot depths again after creating the fretboard radius, this is easier done after the neck is FRET SLOT DEPTH GAUGE - STAINLESS STEEL